Contact Us
Terms of Business
Accessibility Petition
Articles and Solutions

M-Audio Delta 66

D-connector Digital Out Digital In

M-Audio Trigger Finger

Knob C5 = Program Number Knob C6 = MSB Knob C7 = LSB Knob C8 = Pitch
Knob C1 = Note (Minimum in Edit Mode) Knob C2 = MIDI CC Number Knob C3 = Velocity Lock (Max in Edit Mode) Knob C4 = Channel Number
Memory Recall (Save and Exit in Edit mode) Program/Bank Change (Exit in Edit mode) Pad 13 Pad 14 Pad 15 Pad 16
Control Note Mute (Peek in Edit mode) Full/Lock Velocity (Select in Edit mode) Pad 9 Pad 10 Pad 11 Pad 12
Fader 1 = Transpose Fader 2 = Channel Fader 3 = Velocity Curve Fader 4 = Pressure Sensitivity Pad 5 Pad 6 Pad 7 Pad 8
Pad 1 Pad 2 Pad 3 Pad 4


Front Panel

Working up from bottom right- Pause Light Reset/Plus is top right Moving left- Counter/Minus Clock/Set
Rewind Stop Play Fast Forward Record/ID Write

Front Edge

Above this is hold in left position- push & right to open
Short Play/Long Play slider - Short Play in left position Volume Down Volume Up Output Selector switch - Left = On "Phones", Middle = Off, Right = Line

Right Face

Headphone Socket Record Level knob Recording Mode Switch, left = Manual, middle = Music, right = Speech Line In socket Microphone In socket
Below or behind switch

Recording Instructions

  1. Press Pause
  2. Press Record
  3. Press Pause again when ready

Oberheim MC3000D

Front Panel

Main ?Area

write F1 F2 F3 F4 F5 F6 Exit
Slider 1 Slider 2 Slider 3 Slider 4 Slider 5 Slider 6 Slider 7 Slider 8
Zone 1 Zone 2 Zone 3 Zone 4 Zone 5 Zone 6 Zone 7 Zone 8

Right panel

Data Wheel
Cursor Up
Cursor Left Cursor Right
Cursor Down

Number Pad

7 S T U 8 V W X 9 Y Z
4 J K L 5 M N O 6 P Q R
1 A B C 2 D E F 3 G H I
Bank 0 SPACE Enter

Mode Selectors


Rear Panel

MIDI In 1 MIDI In 2 MIDI Thru 1 MIDI Thru 2 MIDI Out 1 MIDI Out 2 MIDI Out 3 MIDI Out 4 MIDI Out 5 MIDI Out 6 MIDI Out 7 MIDI Out 8 display Contrast knob Power switch (Flat uppermost = On)
System Pedal 1 System Pedal 2 System Pedal 3 Zone Pedal 4 Zone Pedal 5 Zone Pedal 6 Zone Pedal 7 Zone Pedal 8 Serial Port for Mouse A/C connector

Yamaha YDP 101

Rear Panel

MIDI out MIDI in Pedal Aux out left Aux out right

Yamaha VL70M

Front Panel

WX In Breath Phones On/Off/Volume

Panel of Small Buttons

Play Edit Util Effect Mode Breath


MIDI/WX Part - Part + Enter Select - Select + Exit Value - Value +

Rear Panel

MIDI Thru Out In Host select To Host DC In Right Out Left/Mono Out

Yamaha MU128

Rear Panel

For audio connections the top socket is the left channel Audio in Audio out DC in To Host Host select switch MIDI in B MIDI in A MIDI out MIDI thru (also MIDI out E with the CBX driver)

Front Panel

A/D input 1 A/D input 2

Near Data Wheel

Right: Part group Left: select

Pad of Small Buttons

Left column: Play Utility Mode Right column: Edit Effect EQ


Left column: Mute/Solo Enter Exit Middle column: Part minus Select minus Value minus Right column: Part plus Select plus Value plus


  1. Press the Utility button
  2. Press the Enter key


Front Panel

Power Input level % Mix Relative FX Balance Routing I/O Alg/Edit 1 Alg/Edit 2 Recall Program Control Up Enter
Tap Utility Bypass 1 Bypass 2 Store Program Control Down Exit

Rear Panel

Power Foot switch MIDI out MIDI thru MIDI in Digital in top Digital out bottom XLR out, right XLR out left XLR in right XLR in left Required TC control channel = 14

Kurzweil K2600

Rear Panel

Mix left D left C left B left A left Sampler low z (stereo right xlr line in left xlr line in mix right D right C right B right A right Footswitches 1, 2, 3 & 4 Breath CC pedal 2 CC pedal 1 LCD contrast MIDI select (thru = right/out = left) MIDI Out, Thru, In SCSI Thru SCSI Master SCSI termination (auto - right/ disabled = left)

ront Panel

Volume slider 3 buttons: top: solo middle: mixdown bottom: MIDI faders 8 control sliders with buttons above buttons, left to right: 1: rotary fast/slow 2: vibrato on/off 3: chorus/vibrato 4: Vibrato depths 1/2/3 5: percussion on/off 6: perc volume loud/soft 7: perc decay fast/slow 8: perc pitch high/low Single button at bottom: record Mode buttons: Column of 5: top 1: program/mute 1/zoom minus 2: Setup / Mute 2 / Zoom + 3: Quick Access / Mute 3 / Sample sec 4: FX / FX Bypass 5 bottom: play / pause Second column: top 1: MIDI / Previous Page / Gain minus 2: Master / Mark / Gain + 3: Song / Jump / Link 4: DISK / Compare 5 bottom: Stop Column of 3: top 1: Channel - bank 2: Layer - zone 3 button = edit Display with soft buttons Diamond of cursor Under diamond, button on its own = exit Under data wheel: Left = minus right = plus Top right of data wheel, 3 buttons with no gap, alphanumerics: Left = 1 and letters ABC Middle = 2, letters DEF right = 3, letters GHI next row: left = 4, JKL 5, MNO 6 PQR NEXT ROW: left = 7, stu 8 vwx Right: 9 yz bottom row: left: plus/minus and upper/lower case middle: zero right: Space Bottom row of 2 buttons: left: Cancel right: enter Above mod wheels: left: SW9 right: SW10

Turn on MIDI Button Notification

    MIDI Mode 7 down cursors to "Buttons" Move data wheel to "On"

Hhard Reset

    Turn off Turn on During "please wait" message press Exit - brings up "Diagnostics" Choose "hard reset" Get to "Reset" option by pressing a single right cursor Press Enter to activate Press up & down cursors together to confirm When done, choose the "Run System" option to continue use

M-Audio OmniStudio

Front Panel

Input 1 socket Pad 1 button Bottom LED is signal 1 Top LED is clip 1 gain 1 knob Ssame for input 2 Above gain 2 is FX send 1 with sends 2 through 4 to its right To the right of the FX sends are 4 LEDs: Top = clip Bottom = signal Left and right relate to monitor levels To the right of Gain 2 is the Headphone level knob for socket 1 Ssocket 1 Socket 2 Llevel knob for socket 2 Mmonitor volume Power Above power is its power status LED Upper LED is phantom power LED

Rear Panel

Bbottom left is 9V DC input Moving right: Phantom power switch Right mix output Left mix output: these seem to be the wrong way around Right monitor outtput Left monitor output Right FX return Left FX return Line input 4 Line input 3 Insert 2 Insert 1 Top left and moving right: Direct outs 4, 3, 2, 1 FX send Stereo auxilliary in 4 Stereo auxilliary in 3 Routing switch 2 Stereo auxilliary in 2 Routing switch 2 Stereo auxilliary in 1 D connector for PCI card Routing sswitch 1 routes Auxilliary in 1 to Wav in 1 and 2 Routing switch 2 routes to Wav 3 and 4

M-Audio Keystation Pro 88

Rear Panel

Power switch DC in Sustain 2 Sustain 1 Volume MIDI in MIDI out USB

Front Panel

Left Panel

Recall Store (with Recall = Memory Dump) Global Channel (with Store = Device ID) Channel Assign (with Global Channel = Control Select) Control Assign (with Channel Assign = Drawbar Mode) Program (with Control Assign = MIDI Out from USB) Data LSB (with Program = Velocity Curve) Data MSB (with Data LST = Control Mute) Zone Range
Zone/Group Zone 1 (Group A) Zone 2 (Group B) Zone 3 (Group C) Zone 4 Octave Minus (Transpose Minus) Octave Plus (Transpose Plus)


Knobs: Faders:

Modulation Panel

A39 = Rewind A40 = FF A41 = Stop A42 = Play A43 = Record

M-Audio MIDISport 2X2

Front Panel:

MIDI in A front left Soft thru switch Keep in for normal or out for no pc control

Rear Panel


M-Audio MIDISport 4X4

Rear Panel


Roland D110

Rear Panel

MIDI Thru MIDI Out MIDI In Multi outs: 6 through 1 Mix out Right Mix Out Left (mono)

Front Panel

Phones Volume Exit Patch Timbre Part up Parameter Up Value UP Write/Copy Edit Part/System Part Down Group Down Bank Down Value/Number down Enter Memory slot MIDI Message light Power

Kenton Control Freak

Rear Panel

DC in MIDI in MIDI out MIDI Thru External input 1 External input 2

Front Panel

Top right keypad: Function keys 1 through 4 Shift Store Left Edit Right Edit Top left with Shift: Learn F key on F key off Exit Bottom left: Shift accelerates data wheel Store snapshot Reset Edit left Global channel Edit right

Reset Procedures

1 Hold down bottom 4 function keys during power on to restore factory defaults 2 Hold down top 4 function keys during power on to completely clear all memories Required Freak control channel = 16

Kenton PlugStation

Rear Panel:

DC in MIDI in MIDI out MIDI thru 44-way SW1000 connector Card slots ADAT socket Audio outs: 8 through 1 Odd numbered ports at the top are the left channel

Front Panel

Power MIDI Received LED Card Active LEDs Data wheel Required PlugStation control channel = 15


Rear Panel

Power MIDI out MIDI in

Front Panel

Mode 1 - XG & GS

Filter cutoff Resonance Vibrato rate Vibrato dep? Vibrrato delay Chorus level Reverb level EG attack EG decay EG release Portamento Pan Volume

Mode 2 - Creative Labs Sound Cards

As above but with no portamento control

Mode 3 - Steinberg rebirth and Standard MIDI

Continuous controllers

Mode 4 - Roland JV

Mode 5 - Yamaha Plg and Standard CC Numbers 40 through 52

Mode 6 - Standard MIDI

Filter cutoff (CC 74) Resonance (CC 71) Modulation (CC 1) Phaser (CC 15) Delay (CC 94) Reverb (CC 91) Chorus (CC 93) Volume envelope attack (CC 73) Volume envelope release (CC 72) Portamento Expression (CC 11) Pan (CC 10) Volume (CC 7)

Snapshot Procedures

Normal press sends all values to midi Out Held down for 3 seconds sends

Oxygen 8V2

Front Panel

Top row: Octave Up/Down rocker

Alesis Expression Pedal